INSTALLATION GUIDE
|
1.
Open battery compartment. Slide ESC off.
|
 |
2.
Remove motor bolt and gear cover.
|
 |
3.
Remove the 4 bolts from the receiver box. Unplug ESC and steering servo
wires from the receiver. Remove antenna.
|
 |
4.
Pull motor back and up to remove.
|
 |
5.
Bolt your 540 sized motor the Tenbol Big Block Motor Mount using the
provided screws with both washers. It is import to make sure the bolts
are not too long, which could result in damage to your motor. Loosely
install your pinion of choice.
|
 |
6.
Slide the motor attached to mount onto the motor pin.
|
 |
7.
Carefully set the gear mesh and tighten the Tenbol Big Block Motor
Mount screw.
|
 |
8.
Place double sided stick tape to mount your ESC. If the ESC is wider
than the original mounts several layers of tape may be built up.
|
 |
9.
The receiver box may need to be cut as shown to clear your motor. If
you do not want to use the receiver box, the tail portion may still be
used to mount the antenna.
|
 |
10.
Route and connect all remaining wires and you are done. Enjoy!
|
 |
NOW SHIPPING!
